problem hopefully solved. i cut the top of the part i wanted to fill with water and found the hole. as its only small, i decided this could probably be taped up or something, so found online a very strong clue purposely for PVC plastic and inflatables, helps patch holes and stops air getting out whilst also being water resistant (perfect). i am going to use the plastic i cut out of the top to stick over the hole in the middle of the central cylinder hopefully stoping air and water through into the main compartment which then can be fully blown up with no interruptions. in theory this should work. in theory. the top image is the stool without the top, after it has been cut out, showing the centre, and the second image is the cylinder with water filled until it reaches the hole, i didn't want water passing through into the main compartment. third image is side view of the water inside the centre bit, works well with a light behind it, so i might play on this in the exhibition. the fourth is the glue i just brought of ebay.
No comments:
Post a Comment